Posted in MMC L200

P2128 – Accelerator Pedal Position Sensor (sub) Circuit High Input MMC L200 IV

 Posted by  Posted on September 29, 2020

OPERATION

  • A power voltage of 5 V is applied to the accelerator pedal position sensor (terminal No. 4) from the engine-ECU (terminal No. 134).
  • The power voltage is earthed to the engine-ECU (terminal No. 136) from the accelerator pedal position sensor (terminal No. 5).
  • The sensor signal is inputted to the engine-ECU (terminal No. 135) from the accelerator pedal position sensor output terminal (terminal No. 6).

    • FUNCTION

  • The accelerator pedal position sensor (sub) outputs voltage which corresponds to the accelerator pedal depression.
  • The engine-ECU checks whether the voltage is within a specified range.

    • TROUBLE JUDGEMENT

  • Battery positive voltage is 6 – 16 V
  • 2 seconds later after the ignition switch has been in “ON” position or the engine has started up
  • Accelerator pedal position sensor (main) is normal
  • Accelerator pedal position sensor (main) output voltage is 0.2 V or higher and 2.8 V or lower.
  • Accelerator pedal position sensor (main) output voltage exceeds 2.4 V for 0.3 seconds.

    • PROBABLE CAUSES

  • Failed accelerator pedal position sensor
  • Open circuit in accelerator pedal position sensor circuit or loose connector contact
  • Failed engine-ECU

    • DIAGNOSIS PROCEDURE

    STEP 1. M.U.T.-III data list

  • Item 10: Accelerator pedal position sensor (sub)

    • Q. Is the check result normal?

    STEP 2. Connector check: C-115 accelerator pedal position sensor connector

    Q. Is the check result normal?

    STEP 3. Perform resistance measurement at C-115 accelerator pedal position sensor connector.

  • Disconnect connector, and measure at harness side.
  • Resistance between terminal No. 5 and earth.

    • Q. Is the check result normal?

    STEP 4. Connector check: C-103 engine-ECU connector

    Q. Is the check result normal?

    STEP 5. Check harness between C-115 (terminal No. 5) accelerator pedal position sensor connector and C-103 (terminal No. 136) engine-ECU connector.

  • Check earthing line for open circuit.

    • Q. Is the check result normal?

    STEP 6. M.U.T.-III data list

  • Item 10: Accelerator pedal position sensor (sub)

    • Q. Is the check result normal?

    STEP 7. Replace the accelerator pedal position sensor

  • After replacing the accelerator position sensor, re-check the trouble symptoms.

    • Q. Is the check result normal?

    Author: admin